Software 2.1.0. available for BMair Connect

Starting from 20th of November, BMair Connect controllers will be delivered with software version 2.1.0. The software has been extensively tested in the field over the past weeks and is ready for release.

ISO 23875 configuration fully available (new)

• AirHub compatible: 1 or 2 Airhubs can be connected to 1 BMair Connect controller
• CO2 iSensor compatible: CON-SENS-CO2
• Performance tests calibration according to ISO 23875

Connect firmware 2.1.0 is mandatory for all Protective ventilation systems that must perform according to ISO 23865. Previous Connect firmware 2.0.0 is not compatible with ISO 23875 certification guidelines.

Introduction of maintenance mode (new)

• The BMair Connect can now be switched to maintenance mode via the app. This feature ensures that service work can be carried out by a service technician.

Other improvements
In addition to new introductions, our R&D department has also implemented improvements:

• Improved lifetime management of iSensors
• Factory reset improved: all memories are erased. Registration can be performed again afterwards.
• Redundant internal memory to improve robustness.
• Data communication from Connect towards BMair portal improved.